Sponsored
XLT wheel mod in under an hour! Sticker / decal color ring
OP
OP
- Thread starter
- #5
yup -with a little tool called stripe-it-all and there "ton of colors" stripe pack-came out perfectly round-I think it looks amazing
Sponsored
OP
OP
- Thread starter
- #7
nice job,how long/difficult to paint the calipers(each one)? not sure if I want to ...trying to stay understated but sure looks goodNice job Jorl! A little wheel Bling goes a long way! I just used pin striping on mine
Super easy, just takes about 10 min between each coat of paint. I did 2 coats of red and 2 of clear on each wheel. I used the paint in the photo, but you can use any color and it doesn't have to be Hi Temp paint (that is what I have used for several years). I used to just paint them and call it good, but the clear coat looks and last much better/longer. Good luck!
OP
OP
- Thread starter
- #9
so did you remove or paint in place? how much cleaningSuper easy, just takes about 10 min between each coat of paint. I did 2 coats of red and 2 of clear on each wheel. I used the paint in the photo, but you can use any color and it doesn't have to be Hi Temp paint (that is what I have used for several years). I used to just paint them and call it good, but the clear coat looks and last much better/longer. Good luck!
The Maverick was only a few days old, so no cleaning other than a wipe off. (you can use brake cleaner if needed). I painted them right on the truck, removed the wheel of course. Just a little bit of masking tape and put a grocery bag over the rest, and paint. Depending on your jack & Jack stand situation, you can do one at a time or two. I was swapping out the Stock XLT wheels & tires with this Mach-E set at the same time.
Sponsored
Last edited:
