START-STOP MODULE MODIFICATION IN TREMOR 2025

[A420QT]

Road trip!

Ha. You ate a little clown.

Sponsored

 

[catrikejoe]

Nothing happened. It modified the parameter, but the Start-Stop button stays on when the engine is turned on.

Might try doing a body module reboot after modifiction and i also found auto stop/start enabled under instrument module that i disabled maybe this will help you

 

[A420QT]

Might try doing a body module reboot after modifiction and i also found auto stop/start enabled under instrument module that i disabled maybe this will help you

Sorry to bother you again. What do you mean by 'instrument module'?. I pressed the Start-Stop button, turned it off, but when I restarted the car, it came back on (with the BDCM module disabled).

 

[catrikejoe]

I did not understand that last part. "I also went into the IP module and disabled it there also."
I disabled it in only one place, where you mentioned. BDCM module.

Without having the Forscan open in front of me i think the correct insturment module is called APIM if so you shoud beable to open same as the bdcm module

 

[catrikejoe]

i will snap some pictures in about 45 min and post for you

 

[Quest]

Without having the Forscan open in front of me i think the correct insturment module is called APIM if so you shoud beable to open same as the bdcm module

IPC

 

[catrikejoe]

i will snap some pictures in about 45 min and post for you

Hope this helps

 

[A420QT]

Hope this helps

Thanks. But that only makes the Start-Stop notification on the Instrument Panel disappear. The Start-Stop button keeps staying on.

 

[catrikejoe]

i will snap some pictures in about 45 min and post for you

Hope this helps also i performed a bdycm module reboot and IPC reboot after performing changes than did the on demand test which will confirm no codes are set.

 

[Rokan]

Hi. Does anyone know which module needs to be modified to set the Start-Stop to off by default?

There is a Spreadsheet on this forum that shows that the Start-Stop is in the PSCM module, but in the Tremor 2025 that option is not directly shown..

Thanks.

When I coded mine to completely off using for scan I remember having to do two modules. The first one was BCM, just shutting off/eliminating ASS then I had to go to the ABS module and code it if in there as well. It sounds odd I know but it has nothing to do with shutting off your abs brakes or anything I just had to shut it off in there after searching around on the internet this was the only way. I don’t know if this works in 25 or 26’s.

 

[Cancunbadlands]

Thanks, but I would like to do it by soft.

Pull the fuse out

Sponsored