DIY - Molle Panel Behind Back Seat

[Thunderbruce]

I was hoping to find a third party molle panel that was designed to fit behind the back seat. I never found anything so I went the DIY route with 1/2" plywood.

I used the existing mounting holes for the BO amp - (that my XL does NOT have )

I designed and 3d Printed the brackets for the cases to sit on. The straps are used to just hold then against the panel.
Nice job! I have to be honest...I put a cross-style lug wrench in there when I bought my Maverick 15 months ago....and haven't looked in there since...

Sponsored

 

[Thex]

I didn't realize there was that much room behind the seat. How thick are your cases? I need to do something similar rather than stacking loose items behind the seat.

The cases are 3" tall. Any thicker and the seat will not latch.
If you notice, the black case is lower. The red case cannot go any lower as it is right above the bolt holding in the jack. If I could lower the red case to the same level as the black one, the seat would latch easier.

 

[Howard]

I didn't think there would be that much space at the top. Thanks

 

[Bobby Chapman]

yes it does.

Nice. That means we have a good amount of shape there.

 

[Comet]

I was hoping to find a third party molle panel that was designed to fit behind the back seat. I never found anything so I went the DIY route with 1/2" plywood.

I used the existing mounting holes for the BO amp - (that my XL does NOT have )

I designed and 3d Printed the brackets for the cases to sit on. The straps are used to just hold then against the panel.

great Idea!!!

Sponsored