Can you buy spare key with programable chip

[Gpp]

I need a spare key to crank and run the truck down the road. but no fob.i have both original keys that work. just want a spare
To unlock door ,crank the truck and hit the road!will these key by picture places on internet be able to do this ?if so any recommendations as to where to do it.

Sponsored

 

[BOB225DUSTER]

I need a spare key to crank and run the truck down the road. but no fob.i have both original keys that work. just want a spare
To unlock door ,crank the truck and hit the road!will these key by picture places on internet be able to do this ?if so any recommendations as to where to do it.

https://www.mavericktruckclub.com/f...ng-yourself-from-a-locksmith-and-owner.27104/

not my post but will help will help with your key quest

 

[Ozarkbeard]

It is possible. I have a chip key (no fob) that will open the door and start the truck. A competent locksmith can cut the key for you. You program it yourself, if you have the two original fob keys.
See BOB225DUSTER's post above.

 

[MetalsGeek]

In your search for a smaller key, be aware that the Maverick uses a "center-mill" key and not a "side mill" key. The blade dimensions are the same (5.5 mm Wide, 3 mm Thick, 6.5 mm Shoulder) BUT the shape of the tip is NOT. The center mill keys have a squared-off blunt tip while the side mill keys have a chisel taper on the thickness at the very tip. A side mill key can tend to jam the pins if cut for a center-mill lock because the taper tends to push them sideways.
The part number for the full remote fob (3-Btn Center-Mill Flip Key; 315 MHZ; L,U,P) is Ford #164-R8269 or StratTec #5939651. Ford's #164-R8130 (StratTec #5923667 or Dorman 99294ST) is a SIDE-mill key and not the correct part. I don't have the part number for a transponder-only key (no remote). I had good support from NorthCoastKeyless.com. It took me a while to find a local locksmith willing to update the software in this equipment to handle my center-mill key, but that was a couple years back. I programmed it myself into the truck but needed both OEM keys for that procedure.

Sponsored