Big 3 upgrade

[Badluckinc]

Those that have done the big 3 upgrade. How did yall go about adding a larger cable from battery to ground with the battery monitor sensor? Thank you.

Sponsored

 

[Busl0adofnuns]

https://a.co/d/d2qN5Ay
Im gonna try this. Move the factory post off to the side, use the zero port for the big 3 idk if ill use the hot side the same way or not. I feel like the ground side will be fine. These trucks seem to be pretty sensitive to voltage ups and downs. I was gonn use a 3 way fused distribution block on the hot side. Just a note I have kicker lx1200.5 and never go below 13v running on stock set up.

 

[Badluckinc]

https://a.co/d/d2qN5Ay
Im gonna try this. Move the factory post off to the side, use the zero port for the big 3 idk if ill use the hot side the same way or not. I feel like the ground side will be fine. These trucks seem to be pretty sensitive to voltage ups and downs. I was gonn use a 3 way fused distribution block on the hot side. Just a note I have kicker lx1200.5 and never go below 13v running on stock set up.

About to drop in a 1200.1 with 2 L7T 10s

 

[Busl0adofnuns]

https://a.co/d/d2qN5Ay
Im gonna try this. Move the factory post off to the side, use the zero port for the big 3 idk if ill use the hot side the same way or not. I feel like the ground side will be fine. These trucks seem to be pretty sensitive to voltage ups and downs. I was gonn use a 3 way fused distribution block on the hot

About to drop in a 1200.1 with 2 L7T 10s

I bet it will be fine without a big 3. If end up doing a mids amp witch you probably will nice speakers on factory unit sucks.

Sponsored