Search results

Solid question, thanks! There are baffles both at the valve cover vent and on the block crankcase vents that certainly help a good deal, but they don't prevent. I dump oil and condensate out of each can on a regular basis. This is just as normal a routine as fuel contamination in a DI engines...

I have not noticed any reception loss, my thinking is the electrical length of the Cravenspeed is at least a match to the oem. Some have reported a decrease in reception, not me.

OEM's do in fact install catch cans, sometimes called separators, generally on higher end vehicles and of a design that requires little to no maintenance by an owner. The devices are well known and work to reduce the amount of crankcase oil in vapor being reingested. A basic catch can from the...

Good luck OP! Truck is too damn much fun to play with..... ;) Installed Tint front windows to match rears Eyebrow tint Front and rear dash cameras Stubby antenna Blacked out LED third taillight Zepped taillights LED's all 'round Tonneau cover Bed mat Lincoln engine cover Mountune catch cans...

Your suspicion that this is all going to be okay is far more theoretical than the info you've been given in this thread -

Dirty pics.....

Can do, give me a bit

235 / 60 / 18. Zero rubbing, no problems at all.

Take a look around in Engineering test mode, I know you can adjust the mpg offset in this mode as I have done it - my mpg is always within .4 of my hand calculated now. Hold down OK while turning key to accessory , ET comes up and you use the up down toggle to scroll menus

I do the same as well, I am talking about the depth of the pad or socket on the factory jack indicating this vehicle is lifted on the pinch weld - not all vehicles are designed that way.

That's a pre 2021 recall. Good info for anyone with some old stands that wants to make sure, but not for those shopping for new. Any vehicle support can fail, including ramps, and any vehicle support can be used incorrectly as well. When I put the truck up on four stands, such as for tire...

I did the $100 alignment after as well, minor adjustments only. So....don't buy the camber bolts like someone I know did.... :cool:

NJBob, the jack pad on the factory jack tells the tale, these pinch welds are designed to lift on the pinch and not on the surrounding. In addition to the arrowhead molded into the plastic indicating the lift point, the pinch weld itself is visibly thicker and has two V's, one on each side of...

Two pages in and no warranty nannies? The safety patrol hasn't jumped on the Zepped taillights? Very well done OP, 10/10 !! :cool:

Good to hear OP. And good on ya for being kind to the grouchy old bastages that couldn't resist crapping in your thread. They need another appointment with this guy

Had it done twice - recalibration is no problem at all.

Make it yours, you'll enjoy it much more! Anyone can stay bone-stock, only you can do you.......

400 fits fine, plenty room to spare. The best part of the larger filter is it the way it chaps the "experts" ass.... :ROFLMAO:

@jeepgrady hold down OK while turning key to accessory , ET comes up and you use the up down toggle to scroll menus

Lots of components down low on this engine installation, I thought about leaving it off until I laid there looking at all of that and decided against leaving it all exposed. Takes me about 90-seconds to drop that cover and push it back out of the way with a screw gun, so not worth it to me. I...