Search results

It's posted somewhere in this thread . Check towards the middle

No issues on my lariat

I did not. But I have a lariat

Yes that's programming. I fought with that for a while. I basically killed off everything that had to do with cameras and turned them on one by one till I got mine working

I don't think I did but it probably wouldn't hurt

Gauge doesn't really matter just as long as it's about the same size as the other stuff. Yes remove the rca wires completely as well as the wires for the other pins mentioned in my original post. Then use the the other removed wires to replace the rca wires allowing it to just pass though

My original post is the 13.2

You need to lengthen it. Apim is down low and it needs to reach to the dash

Buying the newest apim you can find is usually the way to go. Ota updates do not work and there is no way to manually update at this time. As long as your apim is from a newer vehicle than you screen you should be good

Yea I'll have to plug in to the car whenever got my laptop out again. I think I'm pretty much the same as ronr11 but not 100% on that

Lots of YouTube content on how to use it. Just remember always make a backup

Everything still works like day one. I absolutely love wireless android auto. It's pretty much exactly like it was in there from the factory

It will not. Sync 3 apim maxes out at 6-7 in

Everything is here to do it yourself for like a third of the cost. Also don't support that crap company

Yea I filled with YouTube. I don't really care but at the same time I do. And their majorly misleading people

i retrofitted it to my 22 and i love it . super easy and wireless android auto is amazing

Those bastards at fordsync4 stole my picture for their install video

These bastards used my install picture for their cover photo. That is my install of the 13.2 escape screen not theirs

You got everything plugged in? My as built data I think is on one page in here if you want to give that a shot

Did you disconnect the battery. I basically hot swapped mine and had no issues with mine working. From what I've gathered is sync 3 needs to be in and working . And just hot swap for the sync 4