Search results

Thank you! I thought that’s what I saw in your video but this confirms it. I like not having to plug in to the hitch plug too.

On the installation of the lightbar did you have to deal with running the strip over the hole that accesses the spare tire release?

That flex tubing always comes in handy for projects. Also the newer cloth type electrical tape versus the old school stuff is awesome.

Yes it is.

I tucked away inside the top channel of the bed on the driver’s side.

Don’t forget to either unplug or deal with the center speaker which is fed separately from the head unit not the B&O amp.

Yes I did about 12” so they would fit the tie down rails. Plenty of light though.

Yes they are a bit shorter to be the length of the tie down rails. The strips are connected to the bottom of those rails and are out sight. I opted for a cleaner look and there is plenty of light. Also adhesion to any part of the spray in bed liner is not going to hold up long term. Installs...

On Amazon 19mm Latching Push Button Switches SPDT ON/Off Waterproof Black Metal 12V Ring LED with Wire Plug (White) https://a.co/d/fTT0oo4 Also I got the idea about the magnetic switch setup from this Chris Fix video

Thanks. I like your idea about the magnetic switch location. Nice.

So installed the 60” NiLight LED bed light kit in my Lariat. I chose to mount the lights to the bottom of the tie down locking rails. I don’t like seeing LEDs in installs and the light level is more than sufficient. Also the flat surface of the rail bottoms will provide long term adhesion...

Thanks guys. I thought I’d already checked #84 as shown in the manual but have not checked #83 as BlueSpec1 showed. Will check that next.

Can anyone tell me which fuse box and which fuse is the one that goes to the 12 volt outlets in the bed area. The ones designated for the 12 volt accessories.

Where did you mount the strip? On the grille or to the underside of the hood? Did the rubber seal make it hard to close?

Actually rethought the install and have taken some more intense steps to get the tweeters in the factory dash spots by remoting the crossovers by the B&O amp. Unlike a lot of people I actually like the soundstage the windshield gives. I am planning on dealing with the imbalance of the center...

Does the audio settings in Forscan allow adjustments to the ACM (head unit) to control volume levels and or frequency range assigned (crossover) ? The ACM provides direct amplified sound to the center and rear channels in a Maverick B&O system while the Can Bus feeds a digital signal to the...

I ordered those 4 ohm resistors thanks. I’m going to wait to see how efficient the Morel tweeters are and then decide whether to add the resistor to calm the center down some. I prefer the resistor to an L pad as most every L pad I’ve experienced through time gets dirty and noisy. I had to...

It seems like all these replacement solutions for the center speaker are all coaxial with their own tweeter. That added clarity seems like it would enhance the presence of the center sound which we’re trying to tone down to begin with. Not sure what the benefit is to go to a coaxial instead of...

The new door speakers are much better quality and provide more punch to the sound. Adding a real sub and sub amp was dramatic.

How did the resistor work for you? How much of a difference did it make?