Just because you can buy it.....may not mean it works!

[Hrntfixr]

I too got the black matte piece for around the radio knobs. Then I took a chance and got the knob covers that match the desert brown interior trim, I actually like how they look, they popped out nice. Anyway, enjoy the add-on's in the future. I'm going to install the tailgate extender tomorrow.

Where did you get the knob covers??? Link??

Sponsored

 

[Mikew555]

Nice looking truck. I had to wait a year before I got my maverick so I put money back monthly to buy my Accessories. I bought the same bed cover as you but a bunch of stuff I got on Amazon. You're right the 3 layer center council is a pain but for me I use all 3 layers.. I bought a mabett dashboard storage organizer and one that goes in front of the center council. I like it better then a hole. I've done other things but I like those Interior add on's. I also got rid of.the orange and replaced with a black center council organizer. You might want to add on the Maverick letters on your tail gate. To me it shows the rear off Nicely and a tail gate assist is a must.. These are just things I did. I have fun adding things to my truck and I'm sure you will to. Enjoy and have fun driving that beautiful truck.
I'll check those knobs out. I saw them on Amazon.

 

[Derwood]

My new Lariat Hybrid came in this week. I had a pile of stuff ready to install sitting for months. Thought it might be a good time to start a thread on what might have been a waste of money! I really have only one item to complain about. But maybe some tips on others to make them work better.

Most have seen the "organizers" for the center console. It is very deep and honestly you just put stuff in there you hope you never need. So, an organizer seems like a good thing as it allows 3 tier storage. At least you can get to the upper level of junk! Mine was simply a waste of money. I will have a pic below. It won't stay in the top of the console. The tabs don't work and it slips down. Then the tabs make it a pain to get back out. Top piece was just about as bad. With them installed you had to slam the lid to get it to latch. So, out it came for good. While I was looking at installing the trash can that installs off the headrest on the passenger seat....I had an epiphany. That trash can was always in the way if you were in the back seat. Maverick already has incredible storage....so why not put a plastic shopping bag in the console and make it the trash can! Just empty or replace the bag when needed. Cannot really tell it is there until needed!

I also put in the glove box divider. This part works well. But I did put fuzzy cloth tape on it to keep it from rattling.

I installed the black trim piece that surrounds the radio knob section. I don't understand why Ford didn't frame that area in black. This looks SO much better. Easy to install.

I put the removable storage tray in the area behind the screen. This allows you to remove it easily to clean it. Room for french fries and whatever else without cluttering up the dash. Just drops in...but rattled a lot. So I put fuzzy cloth tape under it where it contacted the dash. Good to go!

The Truxmat front and rear floor liners are simply the best I have ever had for any vehicle.

Installed the Truxport roll up tonneau cover. Fits very nice and easy to operate. I prefer a roll up over panel type and this seems nicer than the last brand I had on a previous truck.

So far the Maverick has exceeded my already high expectations. Will start this weekend pulling front fascia to install flat tow setup.

Very nice!

 

[FJM]

Where did you get the knob covers??? Link??

Look what I found on Etsy:
https://www.etsy.com/listing/1256877894/knob-covers-for-ford-maverick-2022?ref=share_v4_lx

 

[FJM]

They even used my pic currently for their site.

 

[Hrntfixr]

They even used my pic currently for their site.

LMAO, they sure did. I looked on Etsy and didn't see them. Thanks for the link.
BTW, what color did you go with?

 

[FJM]

LMAO, they sure did. I looked on Etsy and didn't see them. Thanks for the link.
BTW, what color did you go with?

Go to a

 

[FJM]

Go to a

On Etsy type knob covers for Ford Maverick if link didn’t work. I went with the coffee color which was pretty close to the interior trim. They show different kinds of colors. At first I thought they were just these bottle cap looking things but I was actually impressed with how they looked. I actually dig the desert brown interior.

 

[Hrntfixr]

On Etsy type knob covers for Ford Maverick if link didn’t work. I went with the coffee color which was pretty close to the interior trim. They show different kinds of colors. At first I thought they were just these bottle cap looking things but I was actually impressed with how they looked. I actually dig the desert brown interior.

Link worked, i just didn't see those particular ones when i did my initial search. I got in touch and asked them what was close to the Lariat brown on my interior. They were out of stock, but he is gonna run a set for me.

 

[FJM]

Nice, keep me posted.

 

[lajlmt]

Link worked, i just didn't see those particular ones when i did my initial search. I got in touch and asked them what was close to the Lariat brown on my interior. They were out of stock, but he is gonna run a set for me.

Custom…Like that!

 

[aspenwoody]

I had the console vault dealer installed worthwhile imo I then purchased the console tray. Then I used my DremlAl tool to cut the tray down so that it fits over the vault it keeps stuff from rattling and covers the look of the vault.

Sponsored