Installation of scooter lift.

[NJBob]

I am considering getti.g a tri lift 4000 scooter/wheelchair lift for my Maverick. I have a 22 with 4 K tow. One of the requires is to ha e 12 volts to operate the motor on the lift. Will I be able to utilize the hit h connector for this? I don't know the current draw it needs at this time.

Sponsored

 

[MaverRick]

For my Harmar AL160 lift they ran a separate cable directly to the battery. My lift seems to be getting noisy. Probably time for some lubrication.

 

[mepot101]

You will want to go direct to the battery, they draw a good bit of power to lift a scooter.

 

[NJBob]

You will want to go direct to the battery, they draw a good bit of power to lift a scooter.

Thanks, not sure how much current they drew.

 

[Hot Runr Guy]

Most of the Tri-Lift documentaion indicates a 40 amp fuse/breaker, the 7-pin RV socket is fused at 30 amps. You'll need to run a new circuit.

HRG

 

[NJBob]

Most of the Tri-Lift documentaion indicates a 40 amp fuse/breaker, the 7-pin RV socket is fused at 30 amps. You'll need to run a new circuit.

HRG

Perfect thank you

 

[MaverRick]

You will want to go direct to the battery, they draw a good bit of power to lift a scooter.

I always have the engine running when I use mine. Getting ready now to load up my Wife’s scooter for a trip to Legoland.

 

[NJBob]

I always have the engine running when I use mine. Getting ready now to load up my Wife’s scooter for a trip to Legoland.

Looks nice? We got a Legoland not far from me in NY. May be worth the trip

 

[MaverRick]

We always take the scooter when we go to Legoland! My Wife has two bad knees and it’s about a mile walk to get from the parking lot to the Water park which is where we like to hang out during the summer months!!

Sponsored