Small spacer for iPhone 16 and wireless charge pad (3D print)

gzebrick said:

I knocked this out for the 25 Lariat's wireless charging pad. It goes all the way forward and now when I put my iPhone 16 on the pad (all the way against the spacer) it is properly centered. Before this I had to sometimes fiddle with the phone placement on the pad to make sure it's getting the juice.

https://www.tinkercad.com/things/c8WsMFdmmlE-mavphonebumperv1

great work / how much to sell one to me?

Click to expand...

gzebrick said:

I can send one to you just for shipping but really just cut up a piece of foam, cardboard or something and stick it in there and you should be okay.
1. Put your phone (with case) on the pad pushing it all the way forward.
2. Measure the gap between the bottom of your phone and the front edge of the pad (ex 80mm)
3.. Cut up a spacer that's 1/2 the depth of the measured gap (ex: 80/2 = 40mm)
4. Put the spacer all the way forward on your pad

.. and now when you put your phone in, it will be centered front-to-back!

Click to expand...

gzebrick said:

I knocked this out for the 25 Lariat's wireless charging pad. It goes all the way forward and now when I put my iPhone 16 on the pad (all the way against the spacer) it is properly centered. Before this I had to sometimes fiddle with the phone placement on the pad to make sure it's getting the juice.

https://www.tinkercad.com/things/c8WsMFdmmlE-mavphonebumperv1

Click to expand...