Raptor grill wiring

[SDNative]

I purchased an eBay raptor grill, and wondering how to address the wiring. There is one red wire for the top three grill lights, and there are two yellow, and two black wires for the lower bar lights.

Anyone done this and have advice? (The existing YouTube videos either skip the wiring part, or only wire the upper lights)

thanks!

Sponsored

 

[Baloo]

Wired mine, do not have the lower lights, by splicing into drivers side marker light.

 

[Jbuys]

The two yellow wires will tap into the right and left front turn signals. Right turn signal wire is blue with white and the left is yellow with green. The blacks are all grounds.

 

[SDNative]

I ended up just connecting the single hot and single ground to the side marker and it all works.

I didn’t use the yellow wires, and associated grounds at all.

I assume that connecting the yellows to the turn signals would then make the lower lights blink in sync with the turn lights. But would I also have to disconnect (cut) the primary power source coming from the marker light to these lower lights?

really wish this kit had instructions

thanks again

Sponsored