My Maverick Carbonized Gray with the BAP

[RandyS]

Good afternoon folks!

I ran into a Hyundai Tucson with "Bob" back on October 2nd. I hit his right side of his rear hatch with my middle to left side of my grill and headlight, the impact pushed everything to the right (when looking at the front of the truck) by about 3/8", also gashed the lower front valance and the ford emblem on the grille and a bumper cover. After tear down it also needed a new driver's side headlight housing. What didn't look like much damage, end up being a little over $4000 in damage. I just had in repaired by a shop here in Ames, IA, I'm happy to report they were able to use on Ford OEM Parts, and the fit and finish is spot on. The picture I have attached is prior to the repair, you will need to zoom in to see the license plate bracket is dented, the bumper cover is also damaged and the lower valance is scraped up. I will get an after repair photo when I get a chance after I get it all cleaned up again.

Sponsored

 

[RandyS]

Hello folks,
I am working my way through my build, what I have done so far is: Eibach lowering springs, custom bedside graphic, with some old school pin stripping, and matte black tailgate letters, Lund hood aeroskin,. I will post some pictures here soon after I get it all cleaned up.

Since I plan to show this truck, I am struggling with what to do under the hood? I am looking for ideas on an Engine Cover, I have searched car-part.com and LKQ Online only to have the wrong part shipped to me?

Looking for the 2012 2.5L Ford OEM Cover-part#LX6Z-6A949-B, if some one has one, they will part with, please reach out, thank you.

Good afternoon folks!

I ran into a Hyundai Tucson with "Bob" back on October 2nd. I hit his right side of his rear hatch with my middle to left side of my grill and headlight, the impact pushed everything to the right (when looking at the front of the truck) by about 3/8", also gashed the lower front valance and the ford emblem on the grille and a bumper cover. After tear down it also needed a new driver's side headlight housing. What didn't look like much damage, end up being a little over $4000 in damage. I just had in repaired by a shop here in Ames, IA, I'm happy to report they were able to use on Ford OEM Parts, and the fit and finish is spot on. The picture I have attached is prior to the repair, you will need to zoom in to see the license plate bracket is dented, the bumper cover is also damaged and the lower valance is scraped up. I will get an after repair photo when I get a chance after I get it all cleaned up again.

We'd love to see a photo of your ride! Can't wait to see how your build turns out!

Good moring! It has been while since I posted on my build. Since my little fender bender last fall, it has been reapaire and I continue to add mods. Recently I added several Air Deisgn and Mabett pieces.

 

[MaverickNoticer]

That hood piece looks wild. Is it a different hood or an attachment?

 

[RandyS]

That hood piece looks wild. Is it a different hood or an attachment?

it is the Air Deisgn Hood scope for 22-25 Mavericks.

Sponsored