Flatout suspension setup, Confused

[ParadisePanda]

Hey, I've tried messaging flatout on many occasions and platforms but can't seem to get a response. I recently installed their gr lite kit on my tremor but seems to be having trouble setting it up or at least I think I am. I used their instructions on setting up sag but when it settles I see only about 2 inches of up travel until bumpstop which seems wrong to me. Is there any insight you could give? Any information I would greatly appreciate it.

Sponsored

 

[dandaman]

Any luck on this for you? I installed mines recently as well and my rear is lower than stock. How did you cut the rear rubber piece to put under the rear coils?

 

[ParadisePanda]

Hey, they don't tell you but your settle stroke should be in the middle of travel. So you have to adjust spring perch until that is satisfied and then adjust bottom mount to desired ride height after. As for the rears I'm not sure, my old race shop did they install. Height in the rear you'd just have adjust the collar until you reach the desired height. I only leveled the front to the rears stock height, but that's for full weight of the camp setup. Without the bed setup it's a inch lift from stock tremor.

Sponsored