Search results

A naked bed was measured at 43.75" in the front divider slot and 54.5" for the rear slot. Looks like they have a drop in liner in the Video, so if they say to make the front divider 43.25" then I would make the rear divider 54" to fit with a drop in liner. I assume the spray in liner would take...

There is 4x M8's and also 2x M6 holes forward of that for a factory tie down bracket (not sure if this is a standard or optional one). The DIY video says to cut extrusions to 30", but the photos i see with factory accessory rails are almost the whole length of the bed (longer than 30") and use...

You sir are a gentleman and a scholar. I re-visited this thread just now to look at the chart and try to see who has a build date or VIN based on engine (which is not easy with data entry chart). But this dashboard shows me what I was looking for and so much more. VERY COOL!

Can you confirm your measurement from top of bed rail to highest pt on roof? From the photo it looks like 16-17", but angle of camera may be deceiving me? I was calculating 68.7-(30.1+20.3)=18.3" based on media.ford.com specifications: Vehicle Height Maximum = 68.7" Bed Lift-in Height = 30.1"...

They only spray 1 color at a time. I think its just geometry, lighting, and shadows.

Thanks, I was staring at the bolts and did not understand how they could be more symmetric or look better. Yes, the spot welds look like spot welds. Vehicles use many spotwelds to hold the structural stampings together. It cost money to cover the structure with additional "pretty" panels to...