Search results

OP used a magnet but there is also enough room to install it above the hole too.

if not for it being all wrapped up, I wonder which wire they tapped for power on the tail lights. Both pins 2 and 5 power running lights. I know when I only had power directly from the lights, my stock bulbs had a noticeable issue of power being overdrawn when brake/blinker turned on due to the...

As far as I know. All mavericks have the same 6 pin connector for the tail lights. This should work on all of them pending they did put all 5 wires through.

they are a federally mandated safety device. Any car sold since the 2018 law passed is required to have one and cannot be sold without.

This type of harness does avoid those errors because its not attached to the factory 4 pin connector.

So when I repinned one of their harnesses to work on the maverick in the past. I noticed that low power light bars didnt cause issues but high power ones did. Did they get around this issue or is it only verified to work with their light bars?

This is pretty standard for a recall issue. Its not just 1 dealership but all dealerships that are under a stop sell for any truck affected by this recall. I cant speak to your dealership though. 33,500 OTD for a truck that msrp's at 31k or so isnt that much of a bad deal. Them not checking to...

I did undo both clips and tucked the wire above the first plate

So I did my install earlier and came across the same issue of getting one screw in. No matter how loose I left everything else, I couldnt get them all to thread in at the same time. From what I can tell, the issue might actually lie with our trucks. The panel is pivoting against something on the...

My spare is removed currently but it still feels like it will be a task trying to tight them things under there.

For anyone wondering, those 2 large bolts removed are for the rear bumper assembly. Its recommended to tight to 85 lb. ft. I'm not sure what the smaller bolt removed early in the video is related to so I didnt try to find a spec for it.

Its positioned directly over the hole. The lightbar isnt directly visible at standing height but its bright enough to be seen from a car. The wire going into the tailgate gets pushed to the top of the hole to make it fit. Being honest though, I'll probably try something else after this one. My...

I want them so much. But Id rather have some paintwork done for the same price.

I'd imagine some company will make a kit to swap them. wont be cheap and we'll have to be patient for a while until it comes out.

Looking at the video, im a little impressed. 3 different bypasses so no wire cutting needed. About the only thing I'd say could have been done different is the red wire could have been black to better blend but otherwise those lights look solid.

I know I suggested this elsewhere but some brackets to raise the rear seat. Having some extra room under the rear seats makes it easier to store stuff as well as more room for after market stereos as whats currently there isnt very large.

Just a little halloween light display.

I was under the impression that these were being discontinued. I mean they were only for 4G while most networks are transitioning to 5G primarily. Phone tethering has become more common and doesn't require a separate service to provide so they aren't used as much anymore too.

I'm not saying they did this but 3d printing has gotten pretty good that making a basic vacuum form mold isnt that hard. you can print it with holes and all.

I'd check his post history. He just recently did a thread about them and the other mods on his truck.