Search results

Thanks

Something like this? With the Bluetooth controller

Did it work out for you? Did you find the wiring under the dash/bumper?

I picked up 24 my tremor lariat with sunroof in April for 39,800ish if that helps any.

I think the mods are done for now. Wheel spacers and mud flaps install.

I will agree the dawn moldings fit and match the maverick perfectly. They may not stop all dings but if they stop any then they've paid for theirself.

I don't think the shadow black would look bad against the grey.

I installed the rubber trim with mine. It was a pain to get installed on the fender flares first (take your time and untangle it). I found that installing it on the flare the day before and allowing it to normalize before installing was key to get it to fit properly. Also with the rubber trim...

The rear suspension is different between the two

Here an image right down the side. Id say its about an 1". I have ordered 1 1/4" spacers to fill them out

I also installed some 3m door edge guard under the rubber edge seal to protect the paint 3M Paint Protection Film Roll 0.4... https://www.amazon.com/dp/B0BXYBC5ND?ref=ppx_pop_mob_ap_share Please ignore the tall grass it has rained everyday since I purchased this truck. Finding a dry day to mow...

Ok I installed the rough country fender flares. They went on fine for the most part. Getting the holes aligned is a bear by yourself. Still have two holes to align. My thoughts... The flares appear to be good quality. The fit to the body lines is near perfect. I have a couple of questions (may...

My plug as you can see in the photo I took was a mirror image of what was labeled and pictured by another member. I wonder why the difference? Did it change during the model run or is it a trim level thing? Using the pins and the 8 pin connector I made the patch cable from the overhead lights...

No eco or sport modes on the tremors

I was making two because I wanted options depending on "packaging" hiding wires and stuff. Didn't know which way I wanted to go. Cost wasn't much different if I order at the same time. That part number is much easier to live with! not having to purchase 1600 of them Thank you!!! I will most...

I don't know why I'm always trying to reinvent the wheel. I guess it's the engineer in me. I'm just going to make two pass through harnesses. Using Molex connectors like someone else posted. 12 pin Connector with mouser Part numbers 34824-0124 and 34825-0125 w pin 560023-0423 And the 8 pin...

You could hydrodip it and matte clear over it.

There are three different models. Only the one that tracks your speed(gps) uses the old port I believe. I could be wrong!! And may very well be wrong.

https://www.amazon.com/dp/B0D2D8MR2K?ref_=cm_sw_r_apan_dp_WF1Q4TSM901VZWJF8X9A&starsLeft=1&skipTwisterOG=1 I'm going to try this. The fitcamx uses the same plug for their install. So I'm hoping it will also work without tapping wire or adding a curcuit.

Ford is using a 16 pin plug from some where near the overhead console to install these. Does anyone have the ford install Instructions for the factory accessory?