One of my Mods

[Deleted member 12286]

I really fell in love with the interior of the XLT Maverick. I like things to be different.
I have always done interior lights in all my vehicles.I really like the orange accents in the interior of the Maverick. Online you find led lights that are considered orange but they are truly amber. I found the orange led’s.
I love these.
Mod number 13 up next.

Sponsored

 

[Deleted member 6544]

It's orange! I kinda like it. Good job

 

[Deleted member 12286]

Thanks. It was one of the easiest interiors I have done this to. Easy to run wires and access to the fuse panel.
I was surprised how easy it was to take the center console panels off.
Perfect truck for mods.

 

[Michigan Bill]

OP...could you describe the project in more detail, and provides links to the parts, please? Thanks.

 

[Deleted member 12286]

Here is the light strip I purchased from Amazon. It has wires on both sides of the strip. It can be cut in certain places on the strip which are marked. You can pretty much cut it in half due to wires in both sides of the led strip. You won’t need that much. I had about 3 to 4 feet left over.
I used a 5 amp fuse which is marked not used in passenger side.
I took the side panels off the center console. I attached the front led strip to the metal trim under each side of the dash. I ran a continuous led strip from passenger to driver side.
I than connected power and ground from passenger side to the back seat area. The passenger side trim doesn’t have to be removed to tuck the wire under it. It can be just pushed under it.
I fastened the light strip to the plastic under the seat facing the front seats.
Make sure to use alcohol or grease and wax remover before sticking led strip down.
You would not believe how much dirt and grease came off.
This light strip stuck the best I have ever had. I have done about 10 cars over the years and this was the best double stick tape.

 

[Michigan Bill]

Thanks a lot!

Sponsored