Mabett cab spoiler test fit

[MrShadetree]

I test fitted the spoiler so I could see how it fits and decide whether I should paint to match or leave it black as is. It seems to look blend nicely with the black plastic vertical pieces on either side of the back window.

Sponsored

 

[Geo8866]

I test fitted the spoiler so I could see how it fits and decide whether I should paint to match or leave it black as is. It seems to look blend nicely with the black plastic vertical pieces on either side of the back window.

How does it work when you fold your tonneau cover up against the back window area? Does the piece interfere? I’m assuming your tonneau folds up one more time and can be propped against the back window like a bakflip.

 

[MrShadetree]

How does it work when you fold your tonneau cover up against the back window area? Does the piece interfere? I’m assuming your tonneau folds up one more time and can be propped against the back window like a bakflip.

Tonneau has support rods that keep it from contracting the cab or spoiler.

Even without the support rods the tonneau makes contact just below the spoiler.

 

[Cancunbadlands]

I test fitted the spoiler so I could see how it fits and decide whether I should paint to match or leave it black as is. It seems to look blend nicely with the black plastic vertical pieces on either side of the back window.

Why your B pillar is red?!

 

[MrShadetree]

Because I peeled the black vinyl off. Going to add graphics there.

 

[Geo8866]

Tonneau has support rods that keep it from contracting the cab or spoiler.

Even without the support rods the tonneau makes contact just below the spoiler.

Thanks!

 

[TORQUERULES]

So, what do you think of it? I have mine, just have not installed yet. It fits well that is for sure. I thought about painting mine too but leaving it with the current finish does let it blend in a little.

 

[MrShadetree]

So, what do you think of it? I have mine, just have not installed yet. It fits well that is for sure. I thought about painting mine too but leaving it with the current finish does let it blend in a little.

I like it.

 

[TORQUERULES]

I like it.

I just hope the double-sided tape holds up. I do like that it is thin though.

 

[MrShadetree]

I just hope the double-sided tape holds up. I do like that it is thin though.

I hope it stays put. I forgot to use the provided adhesive promoter.

 

[TORQUERULES]

I had to take mine off as once it was fitted on and the adhesive stuck, I could see quite a bit of the paint around the lower edge and around the third brake light that I did not see during the test fit. It looked horrible on my Cyber Orange truck.

I will say this if anybody's worried about the adhesive. It is very good. It took me a while to get the spoiler off without hurting the paint and it has only been stuck for about 5 minutes.

Sponsored