Thanks for posting; I have been been running into this issue myself and didn't know about this. Has the change had a material effect on charging rate and resting voltage of the battery?
I prefer this solution as it's cheaper and I can enable/disable at will. Also retains the last setting on startup.
https://www.aliexpress.us/item/3256804706650795.html (same as the Focus MK4)
That's not entirely correct depending on when you originally purchased the bulbs of course.
For example, I purchased my set in July '23 with the WT21W for the rear and the newer T3 series 4257 switchbacks for the front. So they knew then that there were needed architectural changes in the T3...
Had the recall done today and am experiencing the same issue :(
Reaching out to Lasfit...I don't think 50% off is all that generous. Should be a free replacement for the trouble.
Direct link to @Barracuda340 's tie down anchors build process https://www.mavericktruckclub.com/forum/threads/maverick-accessories-mods-how-tos-on-my-maverick.23559/page-3#post-449625
Can you share some general instructions on how you made it? Looks like you were able to use one piece of steel stock and just cut the thickness in half to make the two sides? Not sure how you got the nice round edges or the oblong hole. Looks really really nice.
I had this same issue - P0451 and P0496. I also happened to have undercoated the Mav.
Dealer replaced part# NZ6Z-9D333H "Hose - Connecting 1" under warranty today. Notes say they "removed and replaced fuel tank pressure sensor" however. Where is this hose and/or pressure sensor located?
I used blaster surface shield to undercoat my Maverick a few months ago. Took me a few full days to get every nook and cranny I could. Plan to touch up yearly
I have a similar spec trailer (under 4k though loaded) and I would agree that the Airlift 1000 bags for the Maverick (AIL60859) do not help much with leveling. Perhaps if you installed taller ones it would help, but it seems to just reduce bounce as there's less spring travel with the bags...
Why clean behind it? I just can't see that being a regular thing. Maybe one every few years but then why not just replace the plastic rivets? Here is a kit from Harbor Freight that I used which worked well and contains extra plastic rivets...