Hooking up the lariat lights to the XL is really no problem it's the same light same everything except DLR running lights.
So to plug in the XL has a spot on it where there's not a wire because is not necessary so you have to put in the right pin in the plug then hook it to a hot fused wire...
No but mine was a little different I have a XL I put lariat headlights on it had to run separate power
wire to power them that turns on and off by the key switch.
My local Ford dealership that had been there for 60 years went belly up two weeks before Christmas. When Covid first hit the owner of the dealership was one of its first casualties. His son tried his best to keep it going, but sales stopped and after surviving a year couldn't go to auto auction...
Good job!- Good looking welds
Only reason I took crash bar off to weld. I once fried a ECM from a loose ground
on someone else's vehicle that was very $$$ to replace.
I ran the power from the 12 volt pigtail also, made it a lot easier.
Nice to have a lift.
DYI this hitch is not that complicated. If you take off the plastic and the bumper
Cut the two pieces off the top of this and bolt it to the crash bar that's already there without taking it off.
The crash bar and hitch are the same material thickness etc. one just has the hitch welded to it...
FakeCowboy is correct. The complexity of trying to use the system that existing to me is out of the question and so expensive. I myself picked up a XL hybrid with no accessories from a dealer I did not order it.
But I have added, bed liner -lariat lights-welding a trailer hitch to the existing...
It's really the passenger mirror that the problem of having to lean over
and manually adjusted every time the wife gets in the maverick.
What I really looking for Is power mirrors on both sides with simple controls on the inside.
Just wanted to see if anybody had done this on XL.
I know the...
Does anyone know of an aftermarket controllable mirrors that will fit on this maverick.
I did not think I would need them but the wife is taller then me and has to adjust them
every time she gets into the maverick which has turned out to be a hassle.
The biggest thing would be to fit and look...
You are going to have to cut that 2 1/4 inches off the top to make it fit.
if you can get a hold of a four-inch grinder with metal cutting wheel take you probably less than five minutes to do. I have a plasma cutter and a cutting torch in my shop but I used the grinder because is so much...
I plan to do this this week end I will post pictures when I am finished.
So this was my Saturday project took me about five hours to take off the plastic put on the hitch.
I also went ahead and put the wiring and for lights using the E trailer bronco sport harness.
My thanks to Adospeed for...