Search results

Thought it was just the bed side didn't know about the door

If you are a DIYer you can do it in the garage and just have it painted lot of cash saved

Actually an easy repair the whole bed side comes off and gets replaced. Look for a reputable shop

I think it adds a higher end touch

Ok front speakers are in. Had to heat the defrost vent tube to reshap to make room for the speakers

Thats the reason for the forscan software

I wish I knew how to 3d print. Would love to make the grills stand up a bit to help fit stuff

Looking at it I will have to heat the defrost vent for sure. Let's see what else I need to fix. I've done stereos for about 30 years. This one I'm trying to keep looking stock. The shallow 10 rockford will go behind the seat

Under the seat you would lose so much mid information because the seat would muffle it . Bass in non directional so waves go in all directions so you would hear bass

Dam sorry. I mean you could order try and send back if not. Maybe see if you can be a guinea pig. Maybe they let you have it

With b&o you can use a meastro a2b. It states it goes to 24 but my understanding is there is no difference from 24-26 on the b&o

After using forscan and changing the 4 I nch you will hear them

You won't hear the 6.5 under the back seat

Here are the factory speakers next to what I replaced them with. And forscan controls the crossover for the rear

Swapped the rears for a 3 way coaxial rockford fosgate

You will lose staging by putting the 6.5 under the rear seat. I would say just change the factory to a good set of 4 inch in the factory locations

2025 mav hybrid xl on 20 inch wheels. Megan racing coil overs starting my stereo install but travel between miami and lake placid

Adding a set of 3 way components from rockford fosgate is going to a challenge. I already swapped the rear with a 3 way coaxial set of rockford fosgate 4 inch. Im using an Audio control LC7i pro with a pac audio T harness and the LC7i will be feeding a rockford fosgate t1000x5ad and 1 shallow...

Bump stop should not be popping. Make sure everything is tight and torqued

I believe you can put an air bladder inside the coils to pump up when you tow. Just dont remember the company