Search results

So far no problem but it did go 2 years before the problem started happening regularly. The test will be this weekend when the cold hits the area, 0 to 10 highs for 3 days.

Thanks, looked everywhere but couldn't find.

The F-150 switch you listed is. a little different then the switch I have in my 23 XLT. My switch has the fuel door button and cargo light to the left of the knob, this switch only has the cargo light. I’ve looked for a 150 switch with fuel and cargo light but haven't had much luck. Do you...

They replaced my battery with a new one just like the old one and did software update. Will see how this works.

Looked at the battery in my 23 xlt and it is already an agm battery. Hopefully the SSM will fix the problem.

When I asked them to check it, they looked for anything ford might have sent out and said there wasn't anything mentioned. I'm going to mention the AC drain issue but this dealership is not the most trustworthy in my opinion. Probably end up buying an AGM battery then using forscan to update the...

My 23 xlt Hybrid did the drain a few times over the last year but the weather was colder when it happened., wasn't using AC but defrost does use it. I didn't thinking much of it until earlier this fall, now it is everyday. I can drive it 20 miles and an hour later it is trying to save my...

Next will be why my truck locked me out while I was getting gas. A message ran across my screen, didn't catch it, then the locks happened. Have a 23 that has the outside buttons which wouldn't open the truck, window was down lucky but when I tried the inside button nothing happened. I could...

Thanks, I didn't want to make a permanent attachment, might have to change the led sometime

What kind of adhesive did you use to hold the lenses on with? Thinking of adding also, didn't like the lack of side turn signals.

The lenses from GadCad3D, what kind of adhesive did you use? Is it holding pretty good?

Thanks, will keep researching the idea.

Did you ever get the side markers acting as a turn signal? I've seen where the higher side markers had a rehad to make them work but I like them to be lower and not so high.

Has anyone tried connecting these lights to the turn signals? I know there a several posts on making the side markers that are high up close to the mirrors into turn signals but I think I would like them a little lower down on the fender.

Thanks

The attached photo shows the blue outline that is always on. I was wondering if the ambient lights were on all the time too. Yes, I want to be able to dim them but that isn't the question.

In the post there're 3 wires, white for ground, purple for power and yellow is an extra wire. Was wondering if the yellow is a constant on to illuminate the blue ring on the port. My USB port is blue constantly after I turn on the truck, day and night. Post indicated the lights will dim using...

Mu USB port lights up blue when I start my truck, 2023 XLT Hybrid, even when it is daylight out. Could the 3rd wire be a constant voltage wire so the blue light works off of the ignition switch?

I have 23 XLT Hybrid and I don't have any lighting in my foot wells either, did you find any better wiring diagram?