If the temperature of your engine was not sufficient enough too close loop your PCM you would get a code P0125. Or a PO 128 malfunctioning thermostat or low coolant level. I don't think you have anything to worry about. Was your vehicle service recently?
I have a Black Tremor and I am getting blasted with acorns for the last two weeks. However I don't notice any damage from it. What damage do you have? I think the hood is aluminum and that's basically taking the biggest hit on my vehicle.
There were some adjustments that had to be made when I first installed my cover on my Tremor. I hardly get a drop of water in the bed. And it has been tested in the hardest storms this fall out here on the east coast. I agree that most of these covers will initially leak at first. There will...
Just glue the part back on with silicone or some other adhesive. Why waist your time going to the dealer for that. You can probably get the clip from Ford later and remove the tail lamp to get behind it if it doesn't snap in from the bedside. :)
My Tremor had a little less then a 1/4 of a tank of fuel and was not loaded when I placed my gauge on the axle.. I'm still interested in a measurement with a 2" plus lift on an XLT AWD.
Good evening gentlemen and ladies. For all those who are concerned the angle of my axles are around 8-9 degrees. That is not much of a radical angle compared to all the vehicles I've worked on in the last 25 years however due to the ongoing axle problem from some individuals especially with...
Does your manual have an index. I purchased one and it didn't have one and with almost 5000 pages it was impossible to find the content you needed in a timely matter.
I'm not sure. There are lots of suggestions on the forum however I'm thinking of going with just one size taller with 235/70. Don't really need a wider tire on the sand. Just air down to 18 PSI. Your photo looks like you are at D. point or Sore Thumb beach?
On all my vehicles the first 10 years are free of corrosion after that it's down hill and fast if you don't protect it. I would Cosmoline it while everything is new and clean. Salt is the killer and works on the metal in places you can't see even after you think you have washed the heck out of it.
Yes It could void the warranty depending on the dealer. That would apply to the factory warranty and an extended warranty here's an example of what they won't cover and that any modifications could void the warranty...
I just paid off my Maverick loan from Ford credit. You might as well get a quote for them even if it's not a good one then after that you could tell the finance manager it's too high and you're going to your credit union instead. And they will most likely lower it and then see where you stand...