Search results

Welcome! I’m enjoying this forum too.

Oh cool

Removed the rear badge today. It is a 4 piece and fairly straight forward. The double sided tape is the toughest to deal with. When prying the oval from the large base trim piece, take your time and use a microfiber cloth with your plastic pry tools. I marred mine up a bit. The next part is the...

You will need to make sure you add weatherstripping at the front in each corner. It will leak there. You can see it from inside the truck bed. That’s the only issue for me.

Ken Garff in Greeley Colorado. the sticker was still high 36k. If you do some research you’ll find the market is falling especially for Ford. Lots of recalls and inability to make repairs is hurting them. If they don’t budge, go somewhere else.

Roll up hard tonneau cover from Rough Country. It looks great, easy to install and it was affordable.

I just got the 2025 Lobo (Low) package for 34,500 OTD. I financed through Navy Federal at 4.5%. The market is trash right now. Going and ask for 10-15% off MSRP. Stick to your guns. Don’t listen to that’s below invoice. They still make money other ways. JMO. And my experience.

Thanks! It was my first time using vinyl. It was a lot more forgiving than I expected.

:wait: Yes, It is on the outside. Time will tell how well it holds up. I will post any issues that might arise. This is exterior vinyl so I’m hoping it lasts through the summer

Hey Old Sarg! I was a little nervous. I probably could’ve looked for the thread on here about it working fine. It was my first time using vinyl too. Not as bad as I thought it was going to be.

I purchased some vinyl to install a brow on windshield. I cut out around the camera and it seems to work fine so far. I think if you’ve been on the fence about installing one, you should go for it!

I seen one today!

Yes! Those wheels were on everything that was anything.

Why is Surfstar mad? 🤷‍♂️

I would love to see auto makers step up the mini truck market. I think it would step up the popularity and desire to own some of these.

I chose this one because I think it gives the most room fully rolled up. I needed to make sure I could fit two mountain bikes in back. The bed is short so the roll is small.

It is the Rough Country hard rollup. It was very easy and straight forward to install. It’s light enough to do by yourself. Took me about 45 minutes. No tools outside of the ones supplied needed. Hardest part was connecting the dang water drain tubes. :crackup: I haven’t tested the water...

New parts installed!

Those look killer on your truck!