Search results

All mavs have shutters. Mine was built after the recall took effect, so I’m already missing the two. This is definitely something that I’ll need the dealer to look at within the next month/2000mi. As someone else had stated, and what I suspected is I have either a stuck thermostat or a faulty...

I would understand the prevention from freezing shut, but even days where it’s 40-60 degrees they still don’t operate. The first few years I had it, there were no issues, even in colder weather. I’ll probably have to take it in to have the dealer look at it. My biggest concern is it’s not...

I got a ‘23 XLT FX4 and with winter upon us, it’s taking way too long to warm up. As I’m inspecting, I’m noticing the grill shutters aren’t closing when it’s cold. I ran a functions test with a Launch Tool and the shutters will move when commanded. There are no history or stored codes for...

I know it’s been a bit. I kept forgetting to post. I ran the lights on the upper ledge of the bed, not on the lip of the cowling. From there I ran the power cable through the cowling popping out right under the rear glass to the other side. The control box is Bluetooth so I have it tucked behind...

I’m going to sound really stupid. It was the Fuse. Not having anything plugged into or any work done, I expected the fuse to be good. Looked into the grounding wire, and when everything was good I actually pulled the fuse out. It was blown on one of the stems, not the center. Will post what the...

To those mentioning the can bus, part of my testing when I wasn’t getting power was hooking up the light leads to see if maybe my multi meter was bad. I’ll try taking it into ford in the next little bit when I have some warranty work done. See if they see anything or have a tip for me. It just...

I wish it was that simple. I haven’t hooked the lights up yet because I wanted to verify power output. Unfortunately even with the truck running and all of its lights on, the bed outlets have 0 power

I tested the leads with the vehicle running off in the on position and I was only getting maybe 100 mil volts compared to the 12 that it is rated for that’s why I was wondering if there is a thing that I’m missing that’s not allowing the power to get to the outlet

Trying to use the bed 12v power outlets to wire some bedlights but I’m getting 0 power to any of the connections. Checked the fuse box just in case it wasn’t powered from my equipment package, but there’s a fuse there. Everything I see and read is just plug and play into the outlet. Am I missing...