Sounds to me that the drain line from the condenser isn't connected under the dash. That condensation is supposed to be vented through the firewall to drip on the ground.
I read on the forum that 202 hybrids were no longer going to be produced so I stopped by my dealer (South Bay Ford, Gardena, CA). My Lariat Lux, CP360 has a production date of 9/5/22 along with a VIN. The Sales Manager said that the ground transportation had improved around here and that if the...
How does one go about accessing "Ford Chat"? When I go to the Ford website, log on to my account and try to open a chat, I get no response at all. ??? I have been successful in calling them but that is minimally helpful at best.
The dealer (South Bay Ford, Hawthorne, CA) called me yesterday. They said that I am now a priority 2. At the pace their orders are moving, they estimate that my order with go into production in the second half of August. The salesman said the the biggest hassle from their end is the shipping...
Ordered a Lariat Lux/CP360 Hybrid on 10/13/21. Just the routine apologies from Ford since. The dealer says I should be in the next batch based on their experience so far. Yea, sure...
Stopped by South Bay Ford today for a status check. I am finally up to a priority code of 10! Ordered on 10/13/21, Lariat Lux/CP360. The sales manager said they have had 168 orders so far, the longest book in SoCal. They have received something like 15 so far.
Their test strategy represents a single data point in what is a much more complex calculation. I recently drove a 300+ mile trip in our Audi Q5 and averaged just over 32 mpg by leaving the cruise control on 65. Again, only one data point!
After all this, I stopped by my dealer, South Bay Ford today. They said that they had heard of this delivery delay but had no first hand knowledge from Ford as yet. They checked and my order (Lariat lux hybrid) was still valid but no production date yet (ordered 10/13/21). While there, I saw an...
Since this is exposed to all sorts of onlookers, you might want to use a stainless steel tamper resistant bolt. McMaster-Carr offers them in the correct size (M6x1.00x25mm) for $6.27 plus shipping for a pack of 10. You just need to get the correct bit (center pin Torx for an M6 screw). It won't...
I agree with TheGriffin1313. I had a Gulfstream jet repainted by a supposedly competent shop and they shot 2-3 thousandths too much paint on the top of the vertical fin. It took us 2 months to figure out why the Direct TV signal was weak. It turns out that Gulfstream had done a LOT of testing on...