Recent content by Pstewone

I used mine for two camping in the summer of 2025 (total of 10 weeks) with no issue. There is another thread with better information you should look at. My setup components, Victron Orion 18 amp DC-DC charger. 100ah LifePo4 and a compressor frig/cooler wire and fuse etc.

Looks good. They the Orion XS run cool compared to the older models. I use the older model. Is that a Schrader valve next the the Orion? Do you have air-bags. If so, how do you like them?

I gave up on it.

Thank you all ! Someone said, "The normal hybrid eccentricities will eventually become normal" I will try to live be those words and not get to wigged-out by it anymore.

Thank you for your input. Why is it so very, very random? I never know when it will do it. I am really concerned with the issue when I'm towing.

For sure!

With all do respect. There is nothing normal about doing it very, very excessive. Think of it like this, if you had an standard automatic transmission and you were heading down the large hill in drive at 55mph and all sudden you put it in first gear that’s the sensation that I get.

Yes, I am experiencing this! I have a 2025 lariat hybrid with the 4k tow package with 11k miles. After completing a 5000 mile trip, towing 3000 of those miles it happened about 10 times. It also happens when not towing. It’s easier to ignore when going slow or when not towing. But when you have...

I just completed a 3000 towing trip. When climbing demanding mountains I too experienced this RPM change. It is different than "fake shifting" I found this info below that explains it. " The increase in RPM during uphill climbs is a normal characteristic of this system as it works to deliver...

Following

That's right, Ford does not offer it on the Maverick even on the top tier seats.

Following.... Even the 2025 Lariat does offer this. It a pain to adjust when one driver is 5ft. and the other is 6ft. Ford missed the mark on my top trim Maverick.

I used 3/8 strut channel nuts. However, if I had to do it again I would use a good 5/16 nuts. The bolts holes probably would not have to be drilled and it would be a little easier tightening. I think the anchors are available in 1/4, 5/16 & 3/8.