Just don't block the camera.
Only thing with holes should be the blue oval
I pulled mine off and ended up coating the outer ring with Flex Seal to see how it would look. I will probably pull it off again to paint it properly. It is easy to remove. Drop the tail gate.. take off the panel with 8 screws... You can see the 2 nuts that hold the logo. After you remove the nuts it drops down... A cable clips into the camera. Once you remove the cable, it is free. I had trouble figuring out how to separate the bezel from the logo so I covered what I didn't want painted with blue painters tape... Make sure the camera is covered so you don't paint that by mistake. Turned out pretty good. I like the look much better. I also added matte black letters to the back. It is subtle, which a also like on my Alto Blue truck.
That looks sweet!
You could always just tape off and spray part or all of the oval with HyperDip. Easy to peel around desired area and I didn’t even need to cover the backup camera. Easy to remove down the road if you want to as well.
Yours turned out nice. I decided to leave the logo alone and just do the bezel with mine. That bright chrome ring looked really out of place om my Alto Blue. I like that there is very little chrome on the truck. I might add a vinyl overlay in the middle with a different design. I'm also thinking about doing something with my XLT side badges... maybe I will add some mesh in the hollow part.
You could always just tape off and spray part or all of the oval with HyperDip. Easy to peel around desired area and I didn’t even need to cover the backup camera. Easy to remove down the road if you want to as well.
Don't need no stinkin’ badges! Pulled them all off first day. No holes. You’ll need a plastic or wooden spudger with which to pry. Work it………it comes right off.
