RoadMaster Invisibrake Brake System - PSI setting?

[NatD]

Hi all. Just installed Demco base plate with RoadMaster Invisibrake. Wondering what PSI setting members are using with the Maverick Hybrids (I have a 2024)

TIA

Sponsored

 

[dborden]

According to this table from Roadmaster, it’s 15-20 PSI:

https://www.roadmasterinc.com/content/pdf/inv_resource_guide.pdf

 

[MagnusBjorn]

Hi all. Just installed Demco base plate with RoadMaster Invisibrake. Wondering what PSI setting members are using with the Maverick Hybrids (I have a 2024)

TIA

Did you install the baseplate yourself, and if so how was the installation? I'm going to install the same setup when my maverick arrives.

 

[dborden]

I had my Roadmaster baseplate and Invisibrake installed, as well as toad brake monitor light in RV. I had installed by a Roadmaster dealer. Dealer Locator (roadmasterinc.com)

 

[NatD]

I did install the base plate - not difficult. Toughest part is finding a good way of attaching the 6 way plug and break away. Watch some videos from etrailer about removing the fascia - take ur time, no issues. Remember Loctite!!

 

[Karmasect]

I just installed the Demco base plate today. Between watching the videos, reading Demco instructions and comments on this forum it was straight forward…but still took a full day given my snail pace.

Tomorrow I am installing my Invisibrake system (removed from my old toad). Questions: where have folks mounted the actuator cylinder? And was removing the front seat necessary to facilitate installation (it was in my previous car). Thanks

Mark

 

[NatD]

Mark I had a roadmaster tec install it for me. The actuator is under the carpet near the driver door. He did not remove the front seat. The unit is placed under the back seat.

 

[Karmasect]

Thanks. I’ll be pulling trim and carpet in the am.

 

[brlr2000]

I just installed the Demco base plate today. Between watching the videos, reading Demco instructions and comments on this forum it was straight forward…but still took a full day given my snail pace.

Tomorrow I am installing my Invisibrake system (removed from my old toad). Questions: where have folks mounted the actuator cylinder? And was removing the front seat necessary to facilitate installation (it was in my previous car). Thanks

Mark

How did the Invisibrake install work out? I'm considering a self-install, so any tips would be appreciated.

Sponsored