- Thread starter
- #1
I bought two of these, but only ended up using one. AkroHD used to make a cubby mount that fit these. 3D printing your own wouldn't be a challenge either.
You get a wire loomed power harness with bare leads on one end, Molex connector on the other. The USB module has 1 USB-A, 1 USB-C and is backlit.
Molex page: I/O Connectors Part 795405067 | Molex
I use this to drive a wireless charger for my phone and it works great. I'm selling this shipped for less than I paid for just the module. Everything is new, unused.
You get a wire loomed power harness with bare leads on one end, Molex connector on the other. The USB module has 1 USB-A, 1 USB-C and is backlit.
Molex page: I/O Connectors Part 795405067 | Molex
I use this to drive a wireless charger for my phone and it works great. I'm selling this shipped for less than I paid for just the module. Everything is new, unused.
Sponsored