Search results

I installed the baseplate and found there were still issues with reassembling the fascia at the bottom to align the 8 screws. No amount of pulling would allow them to reach. I finally determined that the plastic grid was hanging up on the two tow posts protruding through the grid. Upon further...

There was no indication of a change in the model number or anything else I received. When you go to order, I would ask the supplier to confirm the production date. This redesign was completed at the end of November. Rich

I received the updated baseplate from Demco last week. Unfortunately, the install will have to wait due to the holidays. But I have taken photos of the obvious changes. The crossmember bar is 1/4” higher than the original and the rounded sides have less metal bracing protruding forward which...

I have searched and not found any videos on the Demco Baseplate. However, as an update to my prior post, I have been in communication with Demco regarding the issue with the the shutter operation behind the cross bar and the issues with reattaching the lower screws after the install. They went...

I do not have the 4K towing package, just the straight XLT 2 Wheel Dr. hybrid. I installed one washer on each of the four bolts and two on the support bracket on each side of the bracket where it attaches to the frame. Exactly as they depicted in the parts layout on page one I installed the...

I just installed the base plate. Same experience as BackDoctor. Mine is the XLT and I followed directions to a T! After getting it all back together, I started my truck and could hear the vanes activating and observed them (1 & 5) attempt to move but the movement is blocked by the cross bar and...