Had the opposite happen. I was at Lowe's in New Bern, NC strapping down some 2x6x12s with the tailgate in the half-up position. A young man walked by. He gave my Maverick a good look, then turned around and asked, "How you like your Maverick?" We talked a minutes or two. He was very interested.
I hated the driver's seat in my Tremor XLT. Finally took the time to raise the front of the seat track about 1/2 an inch using some washers. Removed the front seat track bolts and loosened the rear bolts. Took about 30 minutes. The seat is much more comfortable. No more back pain.
2023 Tremor. Zero issues. I grew to hate the front seat until I put about a half inch of washers under the front of the frame to raise the front of the seat. 1000 percent improvement in comfort.
I would use the cargo net to keep trash from blowing out of my truck bed and littering the beautiful countryside in Eastern North Carolina. This net will also prevent me from getting a ticket from the PoPo for littering the beautiful countryside in Eastern North Carolina.
I would look into getting a black wrap on the roof. I am seriously considering having this done. I've seen pictures, but have never seen a black roof on a white Maverick in person. I figure I can remove the wrap if I don't like it. Priced out locally at $250.00
I've searched the forum and online looking for specific differences in the 2025 Ecoboost and the 2022-2024 engine. If anyone knows the specifics or could point me toward a technical article I would greatly appreciate it. Thank you.
My Ford App notified me early one Saturday morning that I had low air pressure in one tire. Sure enough, I went outside and found a half-flat rear tire with a small sheet metal screw in the tread. Pumped the tire up and made it to the tire shop before they closed at lunch. Ford App saved me some...
If the cop told you never to talk to a cop because they always lie, then he was lying when he told you that. Logic dictates you should talk to cops because they never lie.
Very nice. I put mine inside the cubby in the bed. I was afraid mounting it to the cubby door could be problematic when removing the door. You could probably sell those 3D printed housings.