Check with Ford chat and see if they can provide you with a Rail car number (if it was sent via rail). Then try to get updates directly from the rail company automated system. My rail car was marked as bad order (defective) and had to be delayed for repairs.
I've actually used the power folding mirrors on my CX-5 to avoid being blinded by the sun during my bumper to bumper morning commute. The sun would always find the perfect angle to burn my eyeballs as it was rising from the horizon
I’m going to consider myself inside the 700 mile club. I don’t like running the tank so low, but had to get close enough.
The left over was not enough for tomorrow morning’s commute so I had to fill up.
Nicely done! I didn't know the frame would fit upside down. But this is a great alternative as well! Still need to drill into the black part of the bumper, but better looking!
XL order holders need to really consider switching to an XLT. For $2,500, you can most likely save that amount while waiting until it gets built and have a much higher probability of actually getting a Maverick
I have one like that for my wife's bronco (because the ACC sensor is down in that area). It uses two L shape brackets that sandwich the bumper inner lip (it is metal in the Bronco).
On the Maverick I was concerned with the lack of ground clearance if I did something similar, not an issue in the...
No concerns, the shutters close and open, so if "more" air is needed, it might keep the shutters open for longer, but that's about it. Placing it in the center also uses the small shutter area that already covers the radiator, so it's a bit less than what it actually is. Also, given that is it...
I was on top of my dealer non-stop and reminding them all the time to not put it. Definitely looks better
Yes, I left a little bit that tucks inside the groves where I can use long nose pliers to tight them up if needed. I had automotive heavy duty ones that I’ve used to hold oil pan covers and...
Finally got my license plates and used these (affiliate links below) to install them without having to drill the front bumper
License plate holder $10.99
https://amzn.to/49oMbCM
Alternative that brings screws and hardware $12.99
https://amzn.to/3IqpbHB
License plate frame + screws $5.99...