Search results

I love my quikrstuff rack but Velocirax and also Lolo are both awesome vertical options.

I guess the main thing is to make sure you have disc brake clearance if your bike has that.

Thanks! It's getting me by until my quikrstuff one comes in. The 'tire holder' boards are 2x6 with 2x6 joist hangers. I kinda wish I used 2x4 joist hangers to lift the 2x6's a little higher for more tire bite but it's not worth the trouble. The bed slot boards are cut at 7" tall because it...

I kinda tweaked the initial idea because it was sorta in the way of reaching the pocket behind it. I went with an extender cable and tucked it in the back. URWOOW 2 Pack SuperSpeed USB 3.0 Angle Male to Female Extension Cable 6 Inch Convertor Adapter Extender Cord Up Angle and Down Angle one...

Thanks! If you look up at Loneum's post I don't think 5 would fit unless you really did some squeezing. I picked up the cheap Walmart tailgate pad just to see how it would fit and it was much wider than the tailgate. This was a fun build but at some point I'm going with a quikrstuff hitch...

I pieced this 3 bike solution together with scrap wood, joist hangers, tie down anchors, and gear ties. I already had made a cross piece for the back slot as a "grocery area" type divider and just built out the rest from there. It's super quick to assemble/disassemble since the boards just sit...

like the low profile... direct link?

I still like this method. I originally got the 90 degree turndown with the thought of minimizing the bend... then I bent it more hah.

Mainly because I didn't want to commit to sticky stuff in my mav haha :-)

I actually have a usb-c thumb drive in that slot for music. It just wasn't connected in the picture. I did it this way so if I need faster charging, I just remove the MA1 and hardwire the phone. But to answer your question, I have not tried having the phone wires with the MA1 also connected...

I picked up a Motorola MA1 for easy Android Auto. I attached it to a USB 3.0 Adapter 90 Degree adapter to make the install clean and also fully removable instead of sticking it directly to the Mav. It gets the job done!

just the croc liners from amazon :) trying to figure out what to 3d print to use that cubby for a higher phone mount solution also probably going to get that motorola MA1 for wireless android auto still mulling over the bakflip mx4 or x4s

Scored this one in Baton Rouge last week!