Search results

Irish spring soap grated and scattered around the engine bay works for me.

The very first mod I made. It is a one bit change and used FORScan to make it set the default to off. I can turn it on with the switch on the console if I want to.

Is there any reason you can’t refill this transmission from the level plug on the side of the Transmission. Instead of having to take apart the engine bay.

Had a P0446 check engine light come on. Wouldn’t clear would just come back as soon as the truck was started. Put truck on lift loosened the card board on the left side and sure enough the both wires to the solenoid was chewed in two. He got it in 2 places had to splice in about 4 inches of...

It didn’t drip out when I took the fill plug out so I believe it was under filled a bit.

It was Time for the 3rd 5000 mile oil change and from reading on this forum decided to change ptu fluid. Not a hard job but I am glad I did. Old fluid wasn’t to bad but the drain plug had fair amount of black crap on it. Should be good to go for awhile now. Used Motorcraft synthetic fluid.

Here are the instructions You have to change the values in the "AS Built" in the PSCM module address 730-03-01. There are 3 sets of values. In the 3rd set of values change the first two digits from 01 (enabled) to 00 (disabled). Then click write all and follow the key off/on instructions...

Yes you can permanently set the default to off using FORScan There is a topic on this forum with instructions search function.

Liability wise most tire shops will not fix side wall punctures. I have my own tire repair capability I will patch a side wall for my own use.

I had to buy one due to ruining one shortly after buying the Maverick. It was $225 for the tire. They ride smooth and they are quiet. But they won’t stand up the the country roads I drive. I replaced all 4 with Toyo open country.

Mine is 2024 xlt hot pepper red I bought the black lettering from Ford with some of my points it really looks nice. So cruise Ford parts. As far as sticking them on the instruction say to clean with iso alcohol. I have no issues with them coming off.

Use FORScan DISABLE AUTO START STOP BUTTON AND LIGHT 1. Go to HVAC AS BUILT 2. Go to 733-01-05 3. Replace the sixth digit with a "0" as shown below. xxxx-x0xx-xxxx Write the changes

Can you give me the update to turn off the panic alarm

Here is the key I bought. It works likes champ. The dealers have The equipment to cut the key. And can do it by VIN. Your dealer is just trying to screw you. Strattec Transponder Ignition Key 128-Bit Chip 5923293 for Ford 164-R8128

They are complicated to cut. I bought my own chipped blank. And had the dealer cut the key. $8.00 and I programed it using the owners manual.

My dealer only charged me $8.00 to cut the key. Then I used the procedure in owners manual to program it to the truck

I ruined one with just 800 miles on the truck. My cost was $220 for the tire. They are not much of tire. Ruined another one. This time I ordered a set of Toyo open country. They are working well in the snow we currently having.

I have similar issue. I don’t use the fob I use a programmed key. And if I lock the truck via the door switch. And then unlock it with my key I have 12 secs before the alarm goes off. supposedly you can turn off the alarm via FORScan. I have the code for an f150 but can verify that it will work...

I used FORScan to disable mine