DAQ: Dumb assed question (my specialty) Love my ‘24 Maverick Hybrid and “baby it”
Here’s the question. If I drive my hybrid 12K, me being me, will change the oil 4x. BUTTT if 40% of my driving is “electric” my gas motor only ran for 7,200 miles -theoretically 2 pul changes and 1,200 miles into...
I haven’t had a lot of luck sinking by phone to the radio, Bluetooth, etc. In fact, I feel like a complete buffoon at times. I’m curious if there is an upgrade available, eliminate, or make it easy, linking my phone to the electronics, or even better taking out the equation. At 72 this...
I’ve read many articles and suggestions on Maverick preferred oil. I have a 2024 Hybrid and would like to know what is the suggested oil from this group. Thanking y’all in advance.
I have notice that the junction where my tie towns meet the bed rust has formed. A good portion of the rust is rust particles. I appears to me that then the tie downs were drilled for installation the metal shaving were not removed. If the tie downs are a factory install I doubt that is the...
My Maverick has been sitting since Christmas in my garage (I’ve been in Florida). Two concerns with startup 1. 12v battery - assuming it will be a simple charge, and 2. Upper engine lubrication during start up. Assuming dip stick is at the halfway mark I was thinking of adding oil to the full...
2024 Hybrid Thinking of cutting to holes in the lower pan: one to allow a filter wrench and one for a wrench or electric socket. And, should I fabricate covers? Thoughts?
Hemmed and hawed about ridding my truck of slippery drop in floor mat but keeping the four sides intact. Factory soft bed mat slightly oversized thus not a great fit. Removed side tie-downs and floor tie downs and was able to remove floor piece. Laid in soft mat and was able to get it under...
Since I have the drop in liner and purchased a Ford mat, can I replace the floor liner with the mat, thus using the 4 “sides” with the Ford mat. Comments appreciated.
‘24 truck came with drop in liner which I find too slick. Tried to drop in a Ford bed mat but the mat is too big. I see 2 options: pull out the floor piece and replace it with the mat or leave the drop iliner in place and trim the mat. Suggestions?