Search results

With fall here, it's a good time to check out your leaf collection points, right behind the lower hinges of your front doors. This is where much of the gunk that comes off your windshield eventually winds up. The rest of it gets spit forward into the engine bay. You can clean the hinge spot out...

I've been pumping out Maverick 3D print designs lately. Here's a pretty simple quality of life improvement for me. This lets me finally fit my favourite coffee mugs in the front console. It contours and clicks into the spring loaded fingers below. Files available here...

Here is a video kind of explaining the problem. The rear wheel wells have a pocket that collects debris and funnels it into the inside of the rocker panels. So I made up a simple plastic part that just closes off that hole...

I wasn’t very happy with any of the other 3D printed tailgate covers. They have unnecessary overhangs and support or poor fitment. They also leave the drain holes open to dirt from above. This set fits the tailgate stamping exactly and covers every hole from falling debris. The big cable...

Just a simple trash bin that you can empty out and clean. Fits the front console. Prints with no supports. Extra thick walls for durability. https://makerworld.com/en/models/1444745-ford-maverick-front-trash-bin#profileId-1504289

Made from an 8 ft 2X6 and a 12 ft 2X4. I purposefully kept the base pretty narrow so I could get it in and out using the slots in the bed. 2X4 verticals are about 37” to match the roof with foam blocks (no rack).

2023 Hybrid XL. Every now and then when I am stopped with my foot on the brake, I get a gentle low frequency lurching. It’s like someone is rocking my bumper. It doesn’t happen at every stop only maybe once or twice a week. I can’t seem to figure out any pattern to when it happens. I don’t use...

My 2023 Hybrid is about 4 months old now. Until now the brakes have been just fine. We just came back from a ski trip where we driving up and down lots of mountains and sitting in the cold overnight and now the brakes grab hard and jerk the truck when slowing down. It’s super annoying! I...

I just installed a single forward facing dash cam today and figured I’d share a few notes while it’s fresh in my mind. I tapped into fuse 3. The top pin was 12V live (when the ignition is on). I grounded to the M6 stud just below the fuse. The nut has an integrated washer that makes it hard to...

I spent my Ford points on getting two bed cubbies for my XL. Install was easy but I was left with the old cover plates afterwards. Instead of tossing them in the trash I used them to cover up the gaping hole behind the left rear wheel. It doesn’t do a perfect job by any means but it’s better...

I just picked up my XL Hybrid here in Canada and am just trying to figure out all the quirks of this vehicle. Has anyone figured out how to start smoothly from auto-hold mode. I think I like the idea of not having the car creep forward when I let go of the brake, but for the life of me I have...