I looked at a couple of antenna mounts that attach to the third brake light, like this one from Larson. However, I found them to be too expensive for what it is.
So, having time on my day off, I started drawing my own. I have some ASA filament, which is a lot more UV resistant than PLA. I still need to draw the openings on the back, but it is a lot closer. I will probably print one out, to check fitment, tomorrow.
When I am done, I will post it in Thingverse. So, if it works, it will be available for free.
So, having time on my day off, I started drawing my own. I have some ASA filament, which is a lot more UV resistant than PLA. I still need to draw the openings on the back, but it is a lot closer. I will probably print one out, to check fitment, tomorrow.
When I am done, I will post it in Thingverse. So, if it works, it will be available for free.
Show full message↓